![]() ![]() Adjust the headlamp as necessary using the headlamp adjusting screw. NOTE: Align one headlamp while covering the other headlamp.Īlign the headlamps to the horizontal reference line. There is a distinct cutoff in the right portion of the beam pattern. NOTE: The appearance of the VOR beam pattern may vary between vehicles. NOTE: Procedure applies to both left and right headlamps with VOR molded on lens. On the wall or screen, locate the cut off of the beam pattern. NOTE: The cut off of the beam pattern is the horizontal line of the beam pattern where there is MAXIMUM change between light and dark. Turn the low beam headlamps on to illuminate the wall or screen and open the hood. NOTE: Carry out this procedure in a dark environment to effectively see the headlamp beam pattern. ![]() NOTE: Use a 2.4 m (8 ft) section of masking tape for the horizontal reference line.įor vehicles with headlamp bulb center heights below 95 cm (37.5 inches), place the horizontal reference line equal to the headlamp bulb center height.įor vehicles with headlamp bulb center heights between 95 cm - 105 cm (37.5 - 41.5 inches), place the horizontal reference line at the headlamp bulb center height minus 1.3 cm (0.5 inch).įor vehicles with headlamp bulb center heights above 105 cm (41.5 inches), place the horizontal reference line at the headlamp bulb center height minus 2.5 cm (1.0 inch). Measure the center of the headlamp height to ground and record the measurement. NOTE: The bulb center of the low beam bulb is sometimes marked on the lens (circle, crosshair or other mark) or is the center of the low beam reflector, bulb shield or the low beam projector inner lens. Park the vehicle on a level surface approximately 7.6 m (25 ft) from the vertical wall or screen directly in front of it. NOTE: The vertical wall or screen must be a minimum of 2.4 m (8ft) wide. NOTE: Before starting headlamp adjustment, entry conditions must be met.Īir suspension switch must be on (if equipped). Molded in small letters on the headlamp lens is one of the following: VOL and SAE or VOR and SAE. Vehicles are equipped with Visually Optically Aligned Left (VOL) or Visually Optically Aligned Right (VOR) headlamps. #2015 ford focus se manualNOTE: Consult your state vehicle inspection manual for recommended tolerance ranges for visual aiming. NOTE: Refer to the Owner's Literature for the headlamp adjustment screw location. Has your car had the headlamp replaced(aftermarket)? of the owners manual should show where the adjuster is located. Click to expand.Do you have a picture of the light handy, im not home right now so i cant go and check on mine. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |